Placing a Call
Using the handset:
1.
Pick up the handset.
2.
Enter the number, and then press the Send soft key.
Using the speakerphone:
1.
With the handset on-hook, press .
2.
Enter the number, and then press the Send soft key.
Using the headset:
1.
With the headset connected, press to activate the headset mode.
2.
Enter the number, and then press the Send soft key.
During a call, you can alternate between the headset, hands-free speakerphone and handset
modes by pressing the key
, the key or by picking up the handset. Headset mode requires a
connected headset.
Answering a Call
Using the handset: pick up the handset.
Using the speakerphone: press
.
Using the headset: press
.
You can reject an incoming call by pressing the Reject soft key.
Ending a Call
Using the handset: hang up the handset or press the End Call soft key.
Using the speakerphone: press
or the End Call soft key.
Using the headset: press the End Call soft key.
Redial
• Press
to enter the
Placed Calls
list, press
or
to select the desired entry, and
then press
or the
Send
soft key.
• Press
twice when the phone is idle to dial out the last dialed number.
Call Mute and Un-mute
• Press to mute the microphone during a call.
• Press
again to un-mute the call.
Call Hold and Resume
To place a call on hold:
Press or the Hold soft key during an active call.
To resume the call, do one of the following:
• If there is only one call on hold, press
or the Resume soft key.
• If there is more than one call on hold, press
or to select the desired call, and then press
or the Resume soft key.
3
To Next Page
Loading...
Need help?
General
