679948-YTG-A-0111
18 Unitary Products Group
NOTE: All dimensions are in inches. They are subject to change without notice. Certified dimensions will be provided upon
request.
ACCESSORIES
• Hot Water or Steam Coil - Add 6” to overall height
when used
• Supply Air Plenum - Add 24-5/8” to overall height
when used
• Base - Add 23-3/8 inches to overall height when used
FIGURE 10 - UNIT DIMENSIONS - NE240
M
K
L
K
J
H
G
F
5/8
5/8
7/8 KNOCKOUTS FOR POWER
AND CONTROL WIRING
AIR
OUT
AIR
OUT
BLOWER
SECTION
KNOCKOUT
FOR
LIQUID
PIPING
D
D
E
LESS
BOTTOM
PANEL
KNOCKOUT
FOR “N”
OD DRAIN
PIPING
KNOCKOUT
FOR “P” OD
SUCTION
PIPING
5/8 PANEL
5/8 BOTTOM
PANEL
D
1-3/8 KNOCKOUT
FOR
LIQUID PIPING
2-3/4
2-3/4
2-3/4
1-3/8 KNOCKOUT
FOR 1 OD
DRAIN PIPING
2-3/8 KNOCKOUT
FOR
SUCTION PIPING
SMALL SIDE
PANEL
20-3/8
26-3/4
29-1/2
A
B
EVAPORATOR
COIL SECTION
2-5/16
C
AIR
IN
AIR
IN
All dimensions are in inches. They are
subject to change without notice. Certi-
fied dimensions will be provided upon
request.
TABLE 25: UNIT DIMENSIONS - NE240
AB C D E F G H JKLMNP
89-1/2 85 26-1/8 29-1/2 59 2-7/16 15-7/8 12-7/16 20-3/4 16 16 20-3/4 1 1-5/8
TABLE 26: UNIT CLEARANCES - NE240
MINIMUM CLEARANCES 240
Side Air with RETURN AIR opening 24”
Side with SUPPLY AIR opening
1
24”
Side with PIPING CONNECTIONS 24”
Side opposite PIPING CONNECTIONS
2
24”
Bottom
3
-
1. Overall dimension of the unit will vary if an electric
heater, a supply air plenum or a base is used.
2. If the coil has to be removed, this dimension is required
to loosen screws that secure the coil to the unit frame.
This dimension will also be required for blower motor
access if the piping connections are made on the oppo-
site side of the unit.
3. Allow enough clearance to trap the condensate drain
lines.
To Next Page
Loading...
Need help?
General
