EasyManuals Logo

Zanussi ZHRN640K User Manual

Zanussi ZHRN640K
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
have to move them on the cooking
surface.
2.4 Care and cleaning
WARNING!
Do not remove the buttons,
knobs or gaskets from the
control panel. Water may get
inside the appliance and cause
damage.
Clean the appliance regularly to prevent
the deterioration of the surface material.
Switch off the appliance and let it cool
down before cleaning.
Do not use water spray and steam to
clean the appliance.
Clean the appliance with a moist soft
cloth. Use only neutral detergents. Do not
use abrasive products, abrasive cleaning
pads, solvents or metal objects.
2.5 Service
To repair the appliance contact the
Authorised Service Centre. Use original
spare parts only.
Concerning the lamp(s) inside this product
and spare part lamps sold separately:
These lamps are intended to withstand
extreme physical conditions in household
appliances, such as temperature,
vibration, humidity, or are intended to
signal information about the operational
status of the appliance. They are not
intended to be used in other applications
and are not suitable for household room
illumination.
2.6 Disposal
WARNING!
Risk of injury or suffocation.
Contact your municipal authority for
information on how to dispose of the
appliance.
Disconnect the appliance from the mains
supply.
3. INSTALLATION
WARNING!
Refer to Safety chapters.
3.1 Before the installation
Before you install the hob, write down the
information below from the rating plate. The
rating plate is on the bottom of the hob.
Serial number ...........................
3.2 Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
3.3 Connection cable
For a single phase or two phase
connection, use the cable type: H05BB-F
or H03V2V2-F which withstands a
temperature of 90 °C or higher.
To replace the damaged mains cable, use
the cable: H05BB-F or H03V2V2-F which
withstands a temperature of 90 °C or
higher. Contact an Authorised Service
Centre. The connection cable may only be
replaced by a qualified electrician.
3.4 Assembly
If you install the hob under a hood, please
see the installation instructions of the hood
for the minimum distance between the
appliances.
6 ENGLISH

Other manuals for Zanussi ZHRN640K

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zanussi ZHRN640K and is the answer not in the manual?

Zanussi ZHRN640K Specifications

General IconGeneral
Hob typeCeramic
Product colorBlack
Hob width size59 cm
Appliance placementBuilt-in
Cooking zone 2 typeLarge
Cooking zone 3 typeRegular
Cooking zone 4 typeSimmer
Cooking zone 2 power2200 W
Cooking zone 3 power1800 W
Cooking zone 4 power1200 W
Cooking zone 1 positionLeft rear
Cooking zone 2 positionLeft front
Cooking zone 3 positionRight rear
Cooking zone 4 positionRight front
Number of cooking zones4 zone(s)
Simmer cooking zone shapeRound
Cooking zone 3 power sourceElectric
Large cooking zone diameter210 mm
Number of gas cooking zones0 zone(s)
Simmer cooking zone diameter145 mm
Regular cooking zone diameter180 mm
Child lock-
Control typeRotary
Control positionTop right
Residual heat indicatorYes
Large cooking zone2300 W
Connected load (electric)- W
Weight and Dimensions IconWeight and Dimensions
Depth520 mm
Width590 mm
Height- mm
Installation compartment depth490 mm
Installation compartment width560 mm
Installation compartment height38 mm

Related product manuals