Page 32
4.4 FUNCTION CONFIGURATION
4.4.a Traction
Using the CONFIG MENU of the programming console, the user can configure the follow-
ing functions (see "OPERATIONAL FEATURE" chapter for an explanation of "hydraulic
steering function") :
SUBMENU "SET OPTIONS"
1 HOUR COUNTER
- RUNNING: the counter registers travel time only.
- KEY ON: the counter registers when the "key" switch is closed.
2 BATTERY CHECK
- ON: the battery discharge level check is carried out; when the bat-
tery level reaches 10%, an alarm is signalled and the maximum current is reduced to
the half of the programmed value.
- OFF: the battery discharge level check is carried out but no alarm is
signalled.
3 CUTBACK MODE
- PRESENT: input B10 (Minifit), A28 (Amp Saab) is managed as a cutback
speed input.
- ABSENT: input B10 (Minifit), A28 (Amp Saab) is managed as an hand-
brake input.
4 HYDRO KEY ON
- ON / OFF: if this option is programmed ON the traction inverter manages
an hydraulic steering function when the "key" is switched ON (only if the "aux output
#1" option is programmed as "hydro contactor" or as "exclusive hydro").
5 STOP ON RAMP
- ON: the stop on ramp feature (truck electrically hold on a ramp) is
managed for a time established by "auxiliary time" parameter. After this time, the
behavior depends on the "aux output #1" option programmation (see also the follow-
ing table).
- OFF: the stop on ramp feature is not performed.
6 AUX OUTPUT #1
- BRAKE: output B9 (Minifit), A7 (Amp Saab) drives an electromagnetic
brake coil (see also the table below).
- HYDRO CONT.: the inverter manages an hydraulic steering function when the direc-
tion input or brake pedal input are active or a movement of the truck is detected.
- EX. HYDRO: the inverter manages an hydraulic steering function when the
exclusive hydro input is active.
7 PEDAL BRAKING
- ANALOG: the mechanical brake pedal has a switch and a potentiometer
installed. When the accelerator is released and the pedal brake is pushed the in-
verter performs an electrical braking whose intensity is proportional to the brake