Proprietary Statement
This manual contains proprietary information of Zebra Technologies Corporation. It is intended solely for the
information and use of parties operating and maintaining the equipment described herein. Such proprietary
information may not be used, reproduced, or disclosed to any other parties for any other purpose without the
expressed written permission of Zebra Technologies Corporation.
Product Improvements
Continuous improvement of products is a policy of Zebra Technologies Corporation. All specifications and
designs are subject to change without notice.
FCC Compliance Statement
Note: This equipment has been tested and found to comply with the limits for a Class A Digital Device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the product manuals,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
In order to ensure compliance, this printer must be used with a Shielded Power Cord and Shielded
Communication Cables.
“The user is cautioned that any changes or modifications not expressly approved by Zebra Technologies
Corporation could void the user’s authority to operate the equipment.”
Canadian DOC Compliance Statement
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set
out in the radio interference regulations of the Canadian Department of Communications.
Liability Disclaimer
Zebra Technologies Corporation takes steps to assure that its published Engineering specifications and
manuals are correct; however, errors do occur. Zebra Technologies Corporation reserves the right to correct
any such errors and disclaims liability resulting therefrom.
No Liability for Consequential Damage
In no event shall Zebra Technologies Corporation or anyone else involved in the creation, production or
delivery of the accompanying product (including hardware and software) be liable for any damages whatsoever
(including, without limitation, loss of business profits, business interruption, loss of business information, or
other pecuniary loss) arising out of the use of or the results of use of or inability to use such product, even if
Zebra Technologies Corporation has been advised of the possibility of such damages. Because some states do
not allow the exclusion or limitation of liability for consequential or incidental damages, the above limitation may
not apply to you.
Copyrights
The copyrights in this manual and the label printer described therein are owned by Zebra Technologies
Corporation. All rights are reserved. Unauthorized reproduction of this manual or the software in the label
printer may result in imprisonment of up to one year and fines of up to $10,000 (17 U.S.C.506). Copyright
violators may be subject to civil liability.
Zebra
®
,
Barcode Anything
®
, Bar-One
®
, Element Energy Equalizer
®
, Integration w/o Modification
®
, Orion
®
, Stretch
®
, Stripe
®
,
The World’s #1 Name in Bar Code
®
, Track-One
®
, Ultracode
®
, When It’s on the Line
®
, Z-Band
®
, Zebra-Mate
®
, Z-Series™, Z-Ultimate
®
,
ZebraNet
®
, ZPL II
®
, and ZPL
®
are registered trademarks of Zebra Technologies Corporation.
All other trademarks and registered trademarks are property of their respective owners.
Copyright © 2001 Zebra Technologies Corporation. All rights reserved.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
