FCC Statement
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
that may cause undesired operation.
Changes or modications not explicitly approved by the party
responsible for compliance could void the user’s authority to
operate this equipment. Note: this equipment has been tested and
found to comply with the limits for a Class B digital device,
pursuant to part 15 and part 18 of the FCC Rules. These limits are
designed to provided reasonable protection against interference in
a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does not cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measure:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help. The equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. During the operation
To Next Page
Loading...
Need help?
General