Figure 5. Insert the handlebar into the steering column. Adjust the
handlebar to a comfortable height, then secure it into place by attaching
and tightening the locking knob ensuring that it goes all the way through
the pinhole.
Brake Operation & Adjustment
• Squeeze the brake handle to slow the knee scooter.
• Pushing down on each brake handle will engage the brake.
Basket Installation
• Install the basket my aligning the holes located on the baskets mounting plate to the
frame of the knee scooter. Tighten until the basket is secure.
WARNING! If brake adjustment tension is low this may cause the knee scooter to move
even when locked.
Care And Maintenance
Your Zip’r Coaster knee scooter requires a minimal amount of maintenance. The following are
the maintenance items that should be followed to ensure that your knee scooter is both safe and
operational.
Daily
• Always store your knee scooter in a warm and dry climate-controlled environment.
• Always lock in the brakes when getting on and off the scooter. It will ensure extra
stability and keep it from rolling away.
Cleaning
• The knee scooter is made from durable metals along with ABS plastic. The knee scooter
can be cleaned using a damp towel.
• A damp cloth can be used to clean the seat and backrest, ensuring that the backrest and
seat are dry prior to sitting on your knee scooter.
PROHIBITED! Do not apply rubber conditioner on the tire tread; this may cause the
tires to become dangerously slippery.
PROHIBITED! Do not use a rubber or vinyl conditioner on the wheelchairs seat or
backrest, doing so may cause the surfaces to become dangerously slippery resulting in
personal injury and/or damage to your knee scooter.
Maintenance
• Keep the knee scooter stored indoors to avoid moisture and rust.
• Regularly check the tires for wear and replace if worn.
• Do not use a water hose or power sprayer to clean the knee scooter.
• Make sure all nuts and bolts are tight.
• Regularly check brake cables if worn contact Zip’r if worn.
To Next Page
Loading...
Need help?
General
