To Next Page

To Previous Page

Note: For the beginner we recommend automatic timing to achieve best performance. For the

multiple poles motor we recommend high timing to gain best efciency.

6. SBEC Voltage Output

a. Turn on your radio and set the throttle stick to top positon (100%)

b. Plug the battery pack into your controller

c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear

four single beeps to indicate you have successfully entered the programming mode

d. When you hear one long beep and 1 short beep “Beep----Beep” means you are in the SBEC

Voltage Output menu, please choose your desired value by pulling the throttle stick to the

lowest position.

e. The system will automatically enter into next setting item when you nish one . If you do not

want to change other settings, unplug the power to exit.

Option 1 : 5.0V

Option 1 : 5.5V

Option 1 : 6.0V

Note: This feature is only valid for the ESCs with BEC 5A output (45A SBEC-155A SBEC).

7. Governor Mode (Heli)

a. Turn on your radio and set the throttle stick to top positon (100%)

b. Plug the battery pack into your controller

c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear

four single beeps to indicate you have successfully entered the programming mode

d. When you hear one long beep and 2 short beeps “ Beep-----Beep-Beep” means you are in the

Governor Mode menu, please choose your desired value by pulling the throttle stick to the

lowest position.

e. The system will automatically enter into next setting item when you nish one . If you do not

want to change other settings, unplug the power to exit.

1) OFF

5. Timing Setup

a. Turn on your radio and set the throttle stick to top positon (100%)

b. Plug the battery pack into your controller

c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear

four single beeps to indicate you have successfully entered the programming mode

d. When you hear one long beep “Beep-----” means you are in the Timing Setup menu, please

choose your desired value by pulling the throttle stick to the lowest position.

e. The system will automatically enter into next setting item when you nish one . If you do not

want to change other settings, unplug the power to exit.

Automatic (7-30 deg) – ESC automatically detect the best motor timing

Low (7-22 deg) – Setting for most 2 pole motors.

High(22-30 deg)-setting for motors with 6 or more poles.

ZTW Mantis Series User Manual

Questions and Answers: