Using the front panel or remote control, you can change many settings of the amplifier.
Using the remote, press the “Menu” button
F
to enter or exit the menu.
Using the front panel, press and hold the navigation button
4
for 3 seconds.
When entering the menu, the gain setting of the current input will be shown on the display. The top line of the display shows the current option (“Preamp gain” when entering
the menu), and the bottom line shows the current setting.
Using the remote, cycle through the options using the INPUT +
C
and INPUT -
D
buttons.
Using the front panel, press the navigation button
4
to cycle through the options.
Use the VOLUME UP
A
and VOLUME DOWN
B
buttons of the remote, the up and down front panel buttons (
a
/
b
)or the rotary knob
5
to change the settings.
Once in the menu, using the remote, you can cycle through all options in the order shown in the diagram below.
Using the front panel, the amplifier will return to normal operation once cycled through all the options.
MENU FUNCTIONS
SETTINGS FOR INDIVIDUAL INPUTS DISPLAY SHOWS
Preamp gain
Using this function you can set the gain of the selected input. The gain number shown, is the gain between the input and pre out. The
power amp adds 26dBs of gain.
Balance
Using this function, you can change the left/right balance in 6 1dB steps.
Pre out mute
This setting can be set either on or off. With the default setting (On), the pre out connectors are muted with the speakers, when muting
is enabled. With pre out muting off, the pre out connectors will stay on, when the amp is muted. This function can be used e.g. for running
a headphone amp on the pre out connectors. With pre out muting off, you can change inputs and volume setting with muting on. When you
switch off muting again, the volume will return to the previous setting.
Display brightness
You can change the display brightness in four steps: 10, 40, 70 and 100%
7
To Next Page
Loading...
Need help?
General
