3
ENDURA AZ20, AZ25, AZ30 | PUMPED REFERENCE AIR UNIT | INF09/027-EN REV. F
Electrical Safety – CEI / IEC 61010-1:2001-2
This equipment complies with the requirements of CEI / IEC
61010-1:2001-2 ‘Safety Requirements for Electrical Equipment
for Measurement, Control and Laboratory Use’ and complies
If the equipment is used in a manner NOT specified by the
Company, the protection provided by the equipment may be
impaired.
WARNING
• Isolate electrical supplies to the system and reference air
pump enclosure before proceeding with pump
replacement.
• Isolate the air supply to the reference air pump (part
numbers AZ200 770/AZ200 771/AZ200 772/AZ200 773)
before replacing the pump unit.
• Observe all relevant health and safety procedures for
equipment maintenance.
Product recycling and disposal
(Europe only)
not be disposed of in European public disposal
systems after 12 August 2005. To conform to
European local and national regulations (EU Directive
2002/96/EC), European electrical equipment users
must now return old or end-of-life equipment to the
manufacturer for disposal at no charge to the user.
environmental damage or pollution caused by any of
Information on ROHS Directive 2011/65/EU
(RoHS II)
ABB, Industrial Automation, Measurement & Analytics,
by IAMA UK on and following the 22nd of July 2017 and
without any specific exemption, will be compliant to
Service and repairs
Other than the serviceable items listed in this document, none
of the pump’s components can be serviced by the user. Only
personnel from ABB or its approved representative(s) is (are)
components formally approved by the manufacturer should be
used. Any attempt at repairing the pump in contravention of
these principles could cause damage to the pump and corporal
injury to the person carrying out the repair. It renders the
warranty null and void and could compromise the correct
compliance of the pump.
If you have any problems with installation, starting, or using the
pump please contact the company that sold it to you. If this is
not possible, or if the results of this approach are not
satisfactory, please contact the manufacturer’s Customer
Service
Potential safety hazards
operating the system:
• Electrical (line voltage)
To Next Page
Loading...
Need help?
General
