Assembly Instructions / Power2 500-M
2 Safety / 2.3 Occupational safety
© Copyright 2020 ABB. All rights reserved. HZTL455311P0009_EN Rev.A July 2020
2.3 Occupational safety
Occupational safety
WARNING
Injuries to persons
Severe injuries to personnel or fatal accidents can be caused by mechanical
influences as a consequence of hazardous and inadequate operational pro-
cedures or non-compliance with safety and health standards.
u When working on the Power2, always wear safety footwear and protect-
ive clothing to protect against mechanical hazards.
u Keep personal protective equipment in perfect condition.
u Obey mandatory signs.
u Observe the general rules for occupational safety and prevention of acci-
dents.
u Only perform operations that are described in this chapter.
u Only perform operations for which you have received instruction or train-
ing.
Wear safety footwear to protect against mechanical hazard and risk of fall-
ing.
Wear protective clothing.
WARNING
Risk of falling
When work is performed on the low-pressure or high-pressure stage, there
is a risk of falling.
u Do not climb onto the low-pressure or high-pressure stage or onto at-
tached parts and do not use them as climbing aids.
u Use suitable climbing aids and working platforms for work above body
height.
u Only perform work on the low-pressure or high-pressure stage when you are in a physic-
ally and psychologically stable condition.
u Only work with suitable tools, equipment and appliances that function properly.
u Keep the workplace clean; clear away any loose objects and obstacles on the floor.
u Keep the floor, equipment and the low-pressure and high-pressure stage clean.
u Have oil binding agents ready and provide or keep oil pans at hand.
Welding work
u Wear personal protective equipment (PPE) for welding operations.
Page 7 / 29
To Next Page
Loading...
Need help?
General
