ABB REG670 User Manual

Main menu/Settings/General settings/Communication/SLM configuration/
Rear optical SPA-IEC-DNP port
In this submenu SPA or IEC is chosen and the necessary settings for the respective
communication protocols are made.
Main menu/Settings/General settings/Communication/SLM configuration/
Rear optical SPA-IEC port/Protocol selection
SPA and IEC cannot run at the same time and in this submenu one of the options is
chosen.
Main menu/Settings/General settings/Communication/SLM configuration/
Rear optical SPA-IEC port/SPA
When SPA is chosen the baud rate and slave address are set here.
Main menu/Settings/General settings/Communication/SLM configuration/
Rear optical SPA-IEC port/IEC60870–5–103
When IEC 60870–5–103 is used the settings Slave address, Baud rate, RevPolarity
and CycMeasRepTime are done here.
9.2.2.4 Station communication
DNP3.0 for TCP/IP and EIA-485 communication protocol
Main menu/Settings/General settings/Communication/Station communication/
DNP3.0
The DNP 3.0 related parameters are found here.
GOOSE Binary receive
Main menu/Settings/General settings/Communication/Station communication/
GOOSEBinReceive/GB
Includes available instances of GOOSE binary receive (GB) where setting
Operation can be set On or Off.
IEC61850–8–1
Main menu/Settings/General settings/Communication/Station communication/
IEC61850–8–1
Includes settings for the IED name, operation (on/off) and GOOSE.
Multicommand send
Main menu/Settings/General settings/Communication/Station communication/
MultiCommandSend/MT
1MRK 502 014-UEN C Section 9
Read and change settings
39
Operator's manual

ABB REG670 Specifications

General

Brand	ABB
Model	REG670
Category	Protection Device
Language	English