TEIP11, TEIP11-PS I/P SIGNAL CONVERTER | OI/TEIP11/TEIP11-PS-EN REV. M 15
7 Commissioning
Once the installation is complete and the electrical and
pneumatic components are connected, the I/P signal converter
is ready to use. No further adjustment is required.
8 Maintenance
Note
Manipulation by users shall immediately render the warranty for
the device invalid.
To ensure fault-free operation, it is essential that the device is
supplied with instrument air that is free of oil, water, and dust.
The I/P signal converters are adjusted prior to delivery.
After an extensive operating time the signal conversion may
exceed the tolerance limits due to aging or drift.
If the tolerance limits are exceeded, this can be corrected
through adjustment.
Two adjustment screws are used for the adjustment process.
Note
When using a field mount housing first remove the cover to
access the screws.
1 Range 2 Zero point
Figure 9: Adjusting screws
9 Repair
Repair and maintenance activities may only be performed by
authorized customer service personnel.
When replacing or repairing individual components, use original
spare parts.
Returning devices
Use the original packaging or a secure transport container of an
appropriate type if you need to return the device for repair or
recalibration purposes.
Fill out the return form (see Return form on page 17) and include
this with the device.
In accordance with the EU Directive governing hazardous
materials, the owner of hazardous waste is responsible for its
disposal or must observe the following regulations for shipping
purposes:
All devices delivered to ABB must be free from any hazardous
materials (acids, alkalis, solvents, etc.).
Please contact Customer Center Service acc. to page 4 for
nearest service location.
To Next Page
Loading...
Need help?
General
