To Next Page

To Previous Page

- 38 -

5.2 Software / Firmware Upgrade Process

5.2.1 Hardware prepared:

Hardware Requirement:

1. ISP board x 1

2. DSUB VGA cables x 2

3. Printer cable (with one male connector and another female connector) x 1.

4. PC or Notebook with parallel (printer) port x1.

Connect to target monitor

VGA signal input from 15pin D-sub

cable of PC or NB.

Connect ISP board and PC

with printer port cable

Check the Jumpers on the

ISP Circuit Board (make sure

J5, J6, J7, J8 are set at ping

1,2 )

Acer G205H User Manual

Other manuals for Acer G205H