1 Getting started
Preparing to use your Acer n300
7
Rear view
Preparing to use your Acer n300
Perform the following easy installation tasks to begin using your handheld:
• Charge your handheld
• Set up your handheld
• Install the Microsoft
®
ActiveSync
®
software in your computer
• Connect n300 to your computer
• Perform the first ActiveSync operation
Charging your Acer n300
For initial use, you need to charge your handheld for four hours. After that, you can
charge it for a few minutes each day to recharge the battery to full capacity. Normally,
No. Label Description
1 Speaker Outputs audio from your handheld.
2 Battery access
latch
Unlatches the battery cover to remove the battery pack.
3 Battery bay Houses the handheld’s battery pack.
To Next Page
Need help?
General
