11
... English
Installation
Power/Standby
Powering On the Projector
1. Remove the lens cap.
2. Ensure that the power cord and signal cable are securely
connected. The Power LED will flash green.
3. Turn on the lamp by pressing “Power/Standby” button on
the control panel.n And the Power LED will turn green.
4. Turn on your source (computer, notebook, video player ,etc.).
The projector will detect your source automatically.
If the screen displays “Searching”, please make sure the signal
cables are securely connected.
If you connect multiple sources at the same time, using the “Source”
button on the remote control or control panel to switch.
Powering On/Off the Projector
Turn on the
projector first and then
the signal sources.
1
To Next Page
Loading...
Need help?
General
