64 - BIOS utility
BIOS UTILITY
The BIOS utility is a hardware configuration program built
into your computer's BIOS.
Your computer is already properly configured and optimized,
and you do not normally need to run this utility. However, if
you encounter configuration problems, you may need to run
it.
To activate the BIOS utility, press F2 while the computer
logo is being displayed.
Boot sequence
To set the boot sequence in the BIOS utility, activate the
BIOS utility, then press F1 to access the Advanced Setting
to select Boot from the categories listed on the left of the
screen.
Setting passwords
To set a password on boot, activate the BIOS utility, then
press F1 to access the Advanced Settings to select Security
from the categories listed on the left of the screen.
Find Set Supervisor Password and enter a password to
enable this feature. Once you have entered a password for
this feature, you may then enable/disable Password on
Boot.
Remember to select F10 to properly save and exit the BIOS
utility when you are done making changes.
65 / 106 64 / 104 65 / 106
To Next Page
Loading...
Need help?
General