Page 3 of 9
NOTE;
ALL DIMENSIONS ARE IN INCHES (MM).
*Please refer to ASSE 1016-2011 for other test conditions
which may or may not equal installed conditions.
Patent Pending
ROUGH-IN DIMENSIONS:
SPECIFICATIONS:
Acorn Controls Division of Acorn Engineering Company®, A member of Morris Group International™
Manual #7802-116-000
Excessive overheating of valve during soldering
may damage the cartridge and checkstops. Do
not heat valve any higher than needed to flow
solder. If a higher temperature method is being
used all internal components must be
removed. See figures 8 for cartridge removal
and 9 and10 for temperature limit setting.
!
IMPORTANT
1
3
4
" (44)
MIN.
2
1
2
" (64)
MAX.
72"
(1829)
A.F.F.
24"
(610)
REF.
1/2" NPT PLUG
Ø4
1
2
"
(114)
ROUGH-IN
5
1
8
"
(130)
3
3
8
"
(86)
COMBINATION
1/2" NPT AND
1/2" SWEAT
CONNECTIONS
1/2" NPT
FEMALE
CONNECTION
1/2" NPT
FEMALE
CONNECTION
20"
(508)
A.F.F.
24"
(610)
REF.
72"
(1829)
A.F.F.
1
3
4
" (44)
MIN.
2
1
2
" (64)
MAX.
1/2" NPT
CONNECTION
OPTIONAL
TUB SPOUT
FIGURE 2
FIGURE 1
ROUGH-IN
GUIDE
ROUGH-IN
GUIDE
SV16 Installation & Operation Manual
Connections: ................... Combination 1/2" NPT and
1/2” sweat Inlet-Connections
Riser Connection: ...................................... 1/2" NPT
Flow Rate: ........... 4 gpm (15 lpm) @ 45 psi (310 kpa)
Differential
Hot Water Supply Temp.: ........ 110°-180°F (43°-82°C)
Cold Water Supply Temp.: ......... 35°-80°F (1.7°-27°C)
Approach Temperature*: .........................
Maximum Operating Pressure: ........ 125 psi (862 kpa)
Temperature Ranges*: .................
Minimum Flow: ............................................
5°F (2.8°C)
Above Set Point
85°-115°F (29-46°C)
1.25 gpm (4.7 lpm)
Date: 09/01/16
To Next Page
Loading...
Need help?
General