7
5. Assembly Instructions
5.1 Surface Preparation
Before beginning any cleaning task, it is important to inspect the area for objects that could create
a hazard. Remove any objects from the work area that could be tripped over, such as toys or outdoor
furniture. Ensure that all doors and windows are closed tightly.
5.2 Water Supply (Cold Water Only)
Only draw water through the unit. The device must be used with cold water supply only. The water hose
must be at least 1/2” (13 mm) in diameter. The water flow rate must not fall below 2 GPM (7.6 LPM). The
flow rate can be determined by running water for one minute into an empty container. The water supply
temperature must not exceed 40 °C (104 °F).
5.3 Safety Advice
CAUTION
• Never use the pressure washer to draw in water contaminated with solvents (e.g. paint thinners,
gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit. To avoid this risk, we recommend checking the water filter
(located inside the water inlet. To clean it out, refer to the Cleaning and Maintenance section).
• Always prevent debris from being drawn into the unit by using a clean water source and an additional
accessory water filter, if required.
• To prolong the life of the unit, let it rest for 5 minutes aer every 30 minutes of use.
• Check to make sure you have all the parts.
Assembly Instructions
To Next Page
Loading...
Need help?
General
