EasyManuals Logo
Home>AEO>Receiver>RX14 Series

AEO RX14 Series User Manual

AEO RX14 Series
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
RX14x interface definition: (As Picture 1.1) RX14x-E interface definition : (As Picture 1.2)
RX152-Einterface definition:(As Picture 1.3)
AEO RX14x / RX14x-E / RX15x-E Series Mini Micro Receiver
Instruction Manual
Receiver interface definition
Combine receiver and transmitter
Function introduction
1.Turn on the transmitter and power the receiver. At this time, the receiver is in the state of confirming
the transmitter signal, and the LED light flashes slowly.
2.If the transmitter signal cannot be confirmed within 15 seconds, then enter the automatic frequency
matching mode, the receiver starts to search for the signal and perform frequency matching, and the
LED light flashes quickly.
3.If the frequency matching is successful, according to different types of remote transmitters , there will
be a variety of different LED light feedbacks, including but not limited to the following three LED light
flashing methods. Please confirm according to the actual remote control whether the frequency
matching is successful or not.
1.Aileron double servo mode
RX14x-E and RX15x-E (on by default) series receivers have this function.
When your fixed wing aircraft needs two aileron servos on the left and right, please use this function to
simplify the connection of servo and the setting of remote control.
Short circuit the pad at "P" in the figure below to open this function. At this time, CH3 is set to CH4 inverted
output.
If want to cancel this function, please disconnect the pad at "P"(As picture 1.2 1.3)
2.How to use the integrated ESC (5A/1S brushed ESC, 5A/1S brushless ESC, 7A/2S brushless ESC)
RX14x series integrates 5A/1S brushed ESC, RX14x-E series integrates 5A/1S brushless ESC, RX15x-E series
integrates 7A/2S brushless ESC. The brushless ESC supports the DSHOT protocol, doesn’t need to calibrate
the throttle stroke; in addition, the DSHOT signal transmission is faster and the refresh rate is higher; the
response speed of the ESC is much higher than that of the traditional brushless ESC.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AEO RX14 Series and is the answer not in the manual?

AEO RX14 Series Specifications

General IconGeneral
BrandAEO
ModelRX14 Series
CategoryReceiver
LanguageEnglish

Related product manuals