Introduction
Chapter 1 9
Figure 1-4 8485A, 8485A-033, 8485D, 8485D-033 Sensor Accessories
50 GHz Frequency operation (8487A and 8487D)
8480 series sensors that operate up to 50 GHz are fitted with 2.4mm (m) connectors
as standard. To convert the 2.4mm (m) connector for calibration, adapter (2.4mm (f)
to Type-N (m)) is included with the power sensors (shown in Figure 1-5).
NOTE The 2.4mm to Type-N adapter is intended for use only at the 1 mW, 50 MHz power
reference of the power meter. Its function as a calibration reference may be
compromised if used for other purposes.
To Next Page
Loading...
Need help?
General
