Agilent Technologies Infiniium DCA User Manual

1-42
Introduction
New and Revised Commands
New and Revised Commands
This section lists all new and revised commands for the 86100C software revision A.7.00.
Most of the following commands require that Jitter Mode be enabled. Each command listed is
followed by the page number where the command is documented.
Common
Commands
*OPC (Operation Complete) 3-6 (revised to work with PWAVeform:SAVE 10-6)
Disk Commands BFILe? 10-2
TFILe? 10-10
Display
Commands
The following new DISPlay subsystem commands are recommended replacements for the
commands shown in parenthesis.
SINTegrity:BATHtub:YSCale 11-9 (JITTer:BATHtub:YSCale 11-4)
SINTegrity:GRAPh 11-9 (JITTer:GRAPh 11-4)
SINTegrity:HISTogram:YSCale 11-9 (JITTer:HISTogram:YSCale 11-4)
SINTegrity:LAYout 11-10 (JITTer:LAYout 11-5)
SINTegrity:LEVel 11-10
SINTegrity:SHADe 11-10 (JITTer:SHADe 11-6)
Limit Test
Commands
The following new LTESt subsystem command is recommended replacements for the com-
mand shown in parenthesis.
SINTegrity:SELect 15-4 (JITTer:SELect 15-2)
Mask Test
Commands
COUNt:FAILures? 17-4
Measure
Commands
AMPLitude:ANALysis 18-4
AMPLitude:DI? 18-5
AMPLitude:EOPening? 18-5
AMPLitude:ISI? 18-5
AMPLitude:ISIVsbit? 18-5
AMPLitude:ISIVsbit:BITS? 18-6
AMPLitude:ISIVsbit:HIGHest? 18-6
AMPLitude:ISIVsbit:LOWest? 18-6
AMPLitude:LEVel:CIDigits:LEADing 18-7
AMPLitude:LEVel:CIDigits:LAGGing 18-6

Agilent Technologies Infiniium DCA Specifications

General

Brand	Agilent Technologies
Model	Infiniium DCA
Category	Test Equipment
Language	English