GB
25470 591_c
Remove cuttings only when the motor has stopped
Switch off the motor / mower blade when passing
over areas other than those that have to be mowed
Never lift or carry the equipment while the motor is
running
Do not eat or drink when topping up the petrol or
motor oil
Do not inhale the petrol fumes
Move the machine at walking speed
Before use, ensure that all nuts, screws and bolts
are securely fastened.
Assembly
Follow the accompanying assembly instructions.
Caution!
The equipment can be used only after complete
assembly.
Fuelling
Fill the lawnmower with fuel before the initial startup.
Warning - risk of re!
Petrol and oil are highly inammable!
Always observe the operating instructions sup-
plied by the motor manufacturer.
Operating uids
Petrol Motor oil
Grade Regular petrol /
unleaded
Refer to the motor
manufacturer's
instructions
Filling
capacity
Refer to the motor
manufacturer's
instructions
about 0.6 l
Safety
Warning!
Never leave a motor running in an enclosed
space. Toxic hazard!
Store petrol and oil only in containers intended for
this purpose
Only add or drain oil in the open air, and when the
motor has cooled down
Do not add petrol or oil while the motor is running
Do not overll the tank (petrol expands)
Do not smoke when refuelling
Do not open the tank lock when the motor is
running or when hot
Replace the tank or tank lock if damaged
Always close the tank cap rmly
If petrol has been spilt:
Do not start the motor
Do not start the equipment
Clean the equipment
If motor oil has been spilled:
Do not start the motor
Soak up the spilled oil with an oil binding agent
and dispose of appropriately
Clean the equipment
Used oil should not be:
disposed of with domestic rubbish
poured into the sewage system, drains, or
onto the ground
We recommend to collect the used oil in a closed
container and to deliver it to a suitable recycling or
service station.
Adding petrol
1. Unscrew the tank cap, and keep in a clean place.
2. Pour in petrol using a funnel.
3. Firmly replace the cap on the ller opening and
clean it.
Adding motor oil
1. Unscrew the ller cap, and keep in a clean place.
2. Pour in oil using a funnel.
3. Firmly replace the cap on the ller opening and
clean it.
To Next Page
Loading...
Need help?
General
