Viewing PoE Power Supply Status Installing and Managing Power over Ethernet (PoE)
page 3-4 OmniSwitch 6850 Series Hardware Users Guide September 2009
Viewing PoE Power Supply Status
To view the current status of power supplies installed in the backup power supply, use the show power
command, as shown below:
-> show power
Slot PS Wattage Type Status Location
----+----+---------+------+-----------+----------
1 1 -- -- -- --
1 2 360 AC UP External
1 3 -- -- -- --
2 1 510 AC UP External
2 2 -- -- -- --
2 3 -- -- -- --
3 1 360 AC UP External
3 2 -- -- -- --
3 3 -- -- -- --
The backup power supply will always display as “PS-2”. For detailed information on the show power
command output, refer to the CLI Command Reference Guide.
To Next Page
Loading...
Need help?
General
