Avantis Getting Started Guide
6.4 Assigning and un-assigning a channel to a Mix, Group or DCA
Press the Mix key on a Mix, Group or DCA
master strip (i.e. DCA 1)
Hold down the Assign key and press channel
Mix keys to assign or unassign them from the
active mix. Assignment status is displayed in
the Name Block.
6.5 Changing between Sends on Faders and Sends on Rotaries
The default mixing mode is Sends on Faders.
To activate Sends on Rotaries, press the Sends button in the
Strip Rotary Mode section.
In Sends on Rotaries mode, Strip Rotaries are used to
control send levels to the active mix, with the channel
faders remaining as level controls to the Main Mix.
6.6 Setting Pre/Post fader send status
Hold down the Pre key and touch channel
Name Blocks to toggle each source pre or
post fader. Current Pre/Post status is
displayed on the lower part of the Name
Block.
You can quickly set all assignments on or off, or all sources pre or post fader, by touching the Mix Master
Name Block while holding Pre.
To Next Page
Loading...
Need help?
General
