iLive Reference Guide – Hardware Part 1 - 38 AP6526-1 iss.5
Other components available
iPS10 - iLive backup power supply. Optional 2U rack
mounted power supply to provide redundant backup
for the iLive Surface or iDR0 MixRack. Supplied with
DC and status cables.
iLive Editor software
The Editor application runs on a PC or MAC computer to
control the iLive system via Ethernet. Editor is compatible with
both the iLive and the T Series and can be downloaded free of
charge from the Allen & Heath web site. Download either the
PC or MAC version.
The version number of Editor and the firmware running in the
iLive must be compatible. Editor should always be updated
when the system firmware is updated.
Editor may be run offline, connected to a system with MixRack
and Surface, or connected to just a MixRack when a Surface is
not required.
Flight cases - The iLive-112 144 and 176
systems are shipped with touring grade flight cases as
standard. The smallest iLive-80 may be ordered with
or without the flightcase. Cases are not available from
the factory for the T Series surfaces.
AN6329 iDR10 MixRack
flight case
AN7139 iLive-80
Surface flight case
LEDlamp
18” long gooseneck lamp with 4-pin XLR
connector. Features bright, wide dispersion 4
led lamp array with built-in thumbwheel dimmer.
Depending on Surface size up to three lamps
may be used. The iDR10 MixRack also has
provision for a lamp.
80m CAT5 cable drum AH7000
80 meters (264 feet) tour grade Neutrik EtherFlex
cable terminated with EtherCon RJ45 connections.
Approved by Digigram for operation with EtherSound
to 80 meters.