ALLEN & HEATH Qu-16 Getting Started Guide

Qu Mixer Getting Started Guide 14 AP10025 iss1
9. Qu-Start
This section provides a quick guide to get you started setting up and mixing with Qu. For more
information please refer to other sections in this guide and to the Qu Mixer Reference Guide available for
download from www.allen-heath.com/key-series/qu-series.
9.1 Things to check before starting
Mixer firmware version – View current version on the Home
screen. Go to www.allen-heath/key-series/qu-series to check
you are running the latest version. Download and update
using the Setup / Utility / Firmware screen if you are not.
Qu-Pad and Qu-You app versions – The app versions must
be the same as the Qu mixer firmware version. If not, the app
will not connect to the mixer. The Apple Store will always have
the latest version available for free download.
We recommend you turn off your iOS device Auto Update
function to prevent the app being updated before you have
had a chance to update the mixer firmware.
Network and Wi-Fi settings – Plug a router (wireless access
point) into the Qu Network port. Check that DHCP is enabled
in the Setup / Control / Network screen. Check that your
router has a password set. The network should be
independent of any other Wi-Fi in the building.
Current User – View this on the Home screen. Qu has three
User Profiles. Admin user has access to everything and is
typical for the mixer owner or senior engineer. Standard and
Basic users have restricted access as set by Admin.
Passwords can be set.
Calibration – You can recalibrate the motor faders and touch
screen accuracy using the Setup / Utility / Calibration
screen.
Dimmer – To adjust the brightness of the touch screen and
key illumination press and hold the Setup key and turn the
rotary control. Qu powers up with maximum brightness.
9.2 Set a known starting point
To completely reset the mixer you can perform a power up
System Hard Reset. Only do this if absolutely necessary. This
clears all the memories (Scenes, User Libraries, User Profiles
and passwords) and resets all settings to factory default.
To zero the board as a start for setting up a new session or
event you could use the Reset Mix Settings function on the
Scenes page. This is a special Scene that resets all current
mix parameters to factory default. It does not affect the
memories and system settings and preferences.
This reset is not affected by the Global Scene Filter or channel
Safes. It also resets the Global Filter and clears the Safes.
Touch and hold the Reset Mix Settings button for 2 seconds
and then confirm.
To set your preferred starting point you could set up and
store your own template Scene and keep this on USB key as a
backup to load into this and other Qu mixers you may use.
User
Firmware
Touch and hold for 2 seconds

ALLEN & HEATH Qu-16 Specifications

General

Sample rate	48 kHz
Channels quantity	16 channels
Digital sound processing	- bit
Output impedance	75 Ω
Built-in display	Yes
AC input voltage	100 - 240 V
AC input frequency	50/60 Hz
Power consumption (typical)	82 W
XLR out	12
RJ-45 ports quantity	1
Headphone connectivity	6.3 mm
Number of microphone inputs	16
DJ mixer	-
Product color	Black
USB connector type	USB Type-A, USB Type-B

Weight and Dimensions

Depth	500 mm
Width	440 mm
Height	186 mm
Weight	10000 g
Package depth	680 mm
Package width	610 mm
Package height	350 mm
Package weight	13500 g