Allen & Heath 24 XB-14 MK2 User Guide
MASTER SECTION
Audition Out
Standard RCA phono sockets for the Audition bus output. The out-
put level can be controlled by the AUD Level control.
Nominal level = 0dBu, unbalanced.
External Monitor Input
Standard RCA phono sockets for a stereo signal which can be routed
to either the engineers’ CRM monitor headphones & speakers, or the
guest headphones. It can be used for monitoring the program trans-
mission or switching any external stereo source to the engineers or
guests monitors.
The input level can be controlled with the EX MON level control.
Nominal level = 0dBu, unbalanced.
Main PGM Inserts
Standard 1/4” (6.25mm) Jack socket for unbalanced insert send and
return signals.
Wired Tip=send, Ring=return, Sleeve=Chassis. Nominal level is 0dBu.
The insert point is pre the main PGM fader.
Main PGM Outputs
Standard XLR output connector for the main program mix left &
right outputs.
Wired Pin 1=Chassis, Pin 2=hot (+), Pin 3=Cold (-).
Electronically balanced, nominal level = +4dBu (=0VU).
AUX Output
Standard 1/4” (6.25mm) Jack socket for aux output.
Wired Tip=Hot (+), Ring=cold (-), Sleeve=Chassis. Impedance bal-
anced. Nominal level = 0dBu.
Mono Output
Standard RCA phono socket for the Mono PGM bus output.
The mono program bus is Nominal level = 0dBu, unbalanced.
The PGM mono output is a mono version of the main PGM stereo
out but is independent of the main fader.
Headphone Output Sockets
Standard 1/4” (6.25mm) Jack sockets for the engineer/self operator
and two guests.
Wired Tip=Left (+), Ring=Right (-), Sleeve=Ground.
Warning ! To avoid damage to your
hearing do not operate the headphones
or sound system at excessively high
volume. Continued exposure to high
volume sound can cause frequency
selective or wide range hearing loss.
!
L
R
INSERT R
MAIN
AUX
INSERT L
GUEST PHONES 1
GUEST PHONES 2 CRM PHONES
EXT MON IN
L
R
AUD OUT
L
R
MONO
OUT
OU T
PGM
To Next Page
Loading...
Need help?
General
