Allen & Heath 26 XONE:DB4 User Guide
FIRMWARE
When new effects or hardware interfaces are made available for the XONE:DB4
it is possible that the mixer will require new firmware.
New firmware will be made available for download from the website:
www.XONE.co.uk/DB4
Check the website from time to time to check if new firmware is available.
The current version of installed firmware (Code Version) can be found by select-
ing the “About” screen in the Menu. This screen will also display the unique eID
number for your DB4.
Installing new firmware will not overwrite your saved mixer settings.
To install the firmware after you have downloaded it, follows these instructions
carefully:
FIRMWARE UPDATING
Use a good quality USB key of between 32MB and 4GB. Copy any files that you
need to keep, then format the key using FAT32. Unzip the new firmware file to
this key, and plug the key into the USB socket on the mixers front panel.
Open the Menu and scroll down to FIRMWARE, and select this option.
Select “Load File”, and the screen will ask you to confirm that you want to con-
tinue.
Select “YES” and firmware updating will begin. The screen will change to show
a progress bar.
When the update is complete, the mixer will automatically reboot. Avoid pow-
ering the mixer off whilst the update is in progress.
If the mixer freezes during the update or after the reboot, it can forced into a
hard reset by turning the mixer Off at the power switch, then pressing and
holding down the Menu button whilst turning the mixer back On. Hold the
MENU button down for six to eight seconds and then release.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
