Allen & Heath 5 ZED-R16 User Guide
SAFETY INSTRUCTIONS
WARNINGS
-
Read the following before proceeding :
CAUTION
ATTENTION: RISQUE DE CHOC ELECTRIQUE – NE PAS OUVRIR
Read instructions:
Retain these safety and operating instructions for future reference. Adhere to all warn-
ings printed here and on the console. Follow the operating instructions printed in this
User Guide.
Do not remove cover: Operate the console with its covers correctly fitted.
Power sources: Connect the console to a mains power unit only of the type described in this User
Guide and marked on the rear panel. Use the power cord with sealed mains plug ap-
propriate for your local mains supply as provided with the console. If the provided plug
does not fit into your outlet consult your service agent for assistance.
Power cord routing: Route the power cord so that it is not likely to be walked on, stretched or pinched by
items placed upon or against it.
Grounding: Do not defeat the grounding and polarisation means of the power cord plug. Do not
remove or tamper with the ground connection in the power cord.
Water and moisture: To reduce the risk of fire or electric shock do not expose the console to rain or mois-
ture or use it in damp or wet conditions. Do not place containers of liquids on it which
might spill into any openings.
Ventilation: Do not obstruct the ventilation slots or position the console where the air flow required
for ventilation is impeded. If the console is to be operated in a rack unit or flightcase
ensure that it is constructed to allow adequate ventilation.
Heat and vibration: Do not locate the console in a place subject to excessive heat or direct sunlight as this
could be a fire hazard. Locate the console away from any equipment which produces
heat or causes excessive vibration.
Servicing: Switch off the equipment and unplug the power cord immediately if it is exposed to
moisture, spilled liquid, objects fallen into the openings, the power cord or plug be-
come damaged, during lightening storms, or if smoke, odour or noise is noticed. Refer
servicing to qualified technical personnel only.
Installation: Install the console in accordance with the instructions printed in this User Guide. Do
not connect the output of power amplifiers directly to the console. Use audio connec-
tors and plugs only for their intended purpose.
!
WARNING: This equipment must be earthed.
To Next Page
Need help?
General
