Allen-Bradley B Series User Manual

Rockwell Automation Publication 1794-IN082D-EN-P - January 2019 9
FLEX I/O EtherNet/IP Adapters
Install Your Adapter Module
Mount on a DIN Rail Before Installation of the Terminal Base Units
1. Hook the lip on the rear of the adapter (A) onto the top of the
35 x 7.5 mm (1.38 x 0.30 in.) DIN rail (B).
2. Rotate the adapter module onto the rail.
3. Press the adapter down onto the DIN rail until flush.
4. DIN rail locking tab (C) will snap into position and lock the adapter to
the DIN rail.
5. If the adapter does not lock in place, use a screwdriver or similar device
to move the locking tab down while pressing the adapter flush onto the
DIN rail: releasing the locking tab to lock the adapter in place.
6. If necessary, push up on the locking tab to lock.
4 Network cable RJ45 connector (underside)
5 Adapter DIN rail locking tab
6 24V dc connections
7 24V common connections
8 Flexbus connector
9 IP address switches
Component Identification
1794-AENT/B
A
B
C

Allen-Bradley B Series Specifications

General

Brand	Allen-Bradley
Model	B Series
Category	Adapter
Language	English