ITA ENG FRA ESP DEU POR
6-1622081 REV.12 23/09/2020 1 / 6
Control unit AV and AV1
1. Introduction.
LIT LIGHT = FUNCTION ENABLE
3. Electrical connections.
J5 jumper configuration for limit switch or
boton selection.
J5 close: Limit switch selection.
J5 open : Button selection
CONTROL UNTI WITH EXTRACTIBLE MEMORY
Control unit for a motor in alternatine current with torque adjuster (AV1), output contact for limit switch or Open/close bottons, selectable, output con-
tact for photo dispositive, stop button, step-by-step, with radio modular and memory of expansion and possibilità to install an additional card for courte-
sy light and electrolock (AV1).
This control unit has been designed for the automation of rolling shutters, shutters and sliding doors.
2. Configuration.
J2
J3
J4
J5
J1
ATTENTION!! N.C. CONTACTS NOT USED MUST BE
JUMPED TO THE COMMON WIRE LIKE SHOW IN THE
FOLLOWING FIGURE.
The contact 9 and 10 must be jumped to the common only if
jumper J5 is close and the photocellule are not connected.
Optional torque
regulator
(only with AV1).
MIN
MAX
230 VAC
Card options
(only with AV1).
Vac/dc
1 2 3
4
ELS
LC
Vac/dc
FUNCTION SELECTION PRESENT
ON AV AND AV1
( See page 4 ).
J1
Step-by-step / open-close func-
tion selection.
J2
Normal / deadman function
selection.
J3 Fixe code / rolling code selection.
J4
Condominium function enable /
disabile selection.
J5
Limit-switch or button use
selection.
230 Vac
NEUTRAL
PHASE
Photocells power supply
24 Vac 1.5 W MAX
If the torque regulator is used, connect the flashing light (with
self-blinking card) to the output of the torque regulator
Connection for blinker
BRO LIGHT 220 (with
self-blinking card) without
torque regulator
To Next Page
Need help?
General
