- 7 -
INSTALLATION
Read this entire manual before you begin.
BEFORE YOU START
•
Proper installation is the installer's responsibility!
- Write the model & serial numbers on the owner’s manual. The model number label is located on the oven
front. The mounting plate is located on the back side of the microwave oven. See Figure 1.
BE SURE TO READ THE FOLLOWING SAFETY INSTRUCTIONS:
YOUR SAFETY FIRST
FOR YOUR SAFETY:
•
You will need TWO people to install this oven. It is heavy and could cause personal injury if not handled
properly.
•
Avoid Electrical Shock!
- Before you drill into the wall, note where electrical outlets are and where electrical wires might be
concealed behind the wall. YOU COULD GET AN ELECTRIC SHOCK if you contact electrical wires
with your drill bit.
- Locate and disconnect the power to any electrical circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT THE POWER, YOU COULD GET AN ELECTRIC SHOCK.
- You need a DEDICATED 120V, 60Hz, AC only, 15 or 20A, fused electrical supply (located in the cabinet
above the microwave as close as possible to the microwave) serving only the microwave.
To Next Page
Loading...
Need help?
General
