RS2240002 Rev. 1 10
Care and Cleaning
Cleaning Interior, Exterior, and Door
WARNING
To avoid electrical shock which can cause severe
personal injury or death, unplug power cord or open
circuit breaker to oven before cleaning.
Clean microwave oven with mild detergent in warm water
using soft sponge or cloth. Wring sponge or cloth to
remove excess water before wiping equipment. If desired,
boil a cup of water in microwave oven to loosen soil
before cleaning.
• Do not use abrasive cleansers or cleaners containing
ammonia. These could damage finish.
• Never pour water into microwave oven bottom.
• Do not use water pressure type cleaning systems.
Cleaning Splatter Shield
Splatter shield keeps top of microwave oven cavity and
antenna from becoming soiled. Clean soil from shield
with damp cloth or clean with mild detergent and water.
Remove splatter shield for easy cleaning.
1. Unplug oven before removing splatter shield to stop
antenna from rotating.
2. Place fingers behind shield, pull forward, and down.
• When removing and replacing splatter shield, be
careful not to bend antenna.
3. Wash shield in hot, soapy water. Rinse and
dry thoroughly.
• Do not wash splatter shield in dishwasher.
• Do not use abrasive cleaners.
4. Reinstall splatter shield by placing front portion of the
shield in first. Lift until shield slides into holes
located in back of oven.
Correct Installation
Changing Oven Light Bulb
CAUTION
To avoid electrical shock hazard unplug power cord or
open circuit breaker to microwave oven before replacing
light bulb. After replacing light bulb, reconnect power.
CAUTION
To avoid burns and cuts, wear gloves to protect hands
should bulb break. If hot, allow bulb to cool.
Tools and Bulb
• Protective gloves
• Standard screwdriver or ¼ inch socket
• Light bulb rated 120 volt, 25 watt
1. Unplug oven.
2. Remove screw from side of oven and remove access
cover.
3. Remove bulb by turning counterclockwise, being
careful not to burn fingers or break bulb.
• Replace with bulb rated 120 volt, 25 watt.
5. Reverse procedure to reassemble.
To Next Page
Loading...
Need help?
General
