Amana HDC12 User Manual

RS2240002 Rev. 1 32
Disassembly
WARNING
!
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.
To remove lamp,
turn in direction
shown.
High Voltage Transformer
1. See “Component Location” Figure 3, for location.
2. Unplug power cord from power source.
3. Remove outer case and back panel.
4. Remove screws securing transformer to chassis.
5. Pry upward and back to release transformer from
chassis.
6. Remove wire connections from transformer.
7. Reassemble transformer in reverse order.
Capacitor
1. See “Component Location” Figure 3, for location.
2. Unplug power cord from power source.
3. Remove outer case and back panel.
4. Remove screws securing auto transformer to
chassis.
5. Discharge capacitor and remove wires from
terminals.
6. Remove capacitor bracket mounting screw.
7. Reassemble capacitor in reverse order.
Power Cord
1. See “Component Location” Figure 3, for location.
2. Unplug power cord from power source.
3. Remove outer case and back panel.
4. Disconnect wiring.
5. Remove strain relief by compressing with pliers.
6. Remove power cord.
7. Reassemble power cord in reverse order.
Lamp Receptacle
1. See “Component Location” Figure 3, for location.
2. Unplug power cord and remove lamp access panel.
3. Unscrew lamp from receptacle.
4. Disconnect wire terminals to receptacle.
5. Drill out rivet securing receptacle to exhaust duct.
6. Reassemble receptacle in reverse order.
Replacing Oven Lamp
WARNING
!
To avoid electrical shock which can cause severe
personal injury or death, unplug power cord or open
circuit breaker to oven before replacing lamp. After
replacing lamp, restore power.
CAUTION
!
To avoid personal injury or property damage, observe
the following:
• Allow oven and lamp to cool.
• Wear gloves when replacing lamp.
Tools Needed
• Protective gloves
• Screwdriver
• 25-watt, 120-volt appliance bulb (available from
authorized distributor or servicer)
1. Remove screws from access cover on side panel of
oven exterior.
2. Remove old lamp and replace with new lamp.
3. Replace access cover and screw by reversing
procedure in step 1.

Amana HDC12 Specifications

General

Brand	Amana
Model	HDC12
Category	Microwave Oven
Language	English