7
Grounding Instructions
WARNING
To avoid risk of electrical shock or death, this oven
must be grounded.
WARNING
To avoid risk of electrical shock or death, do not alter
the plug.
This oven MUST be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the
electric current. This oven is equipped with a cord having
a grounding wire with a grounding plug. The plug must
be plugged into an outlet that is properly installed and
grounded.
Consult a qualified electrician or servicer if grounding
instructions are not completely understood, or if doubt
exists as to whether the oven is properly grounded.
Do not use an extension cord. If the product power cord
is too short, have a qualified electrician install a three-
slot receptacle. This oven should be plugged into a
separate 60 hertz circuit with the electrical rating as
shown in the appropriate drawing. When a microwave
oven is on a circuit with other equipment, an increase in
cooking times may be required and fuses can be blown.
Model NEMA
Designation
Receptacle and
Plug
RCS10
RCS10MP
RCS10MPS
NEMA
5-155-20P
120V-15P
RFS10S
RFS12S
RF12MPS
NEMA
5-20R/5-20P
120V-20AMP
Mise à la terre
DANGER
Pour éviter tout risque d’électrocution, voire de décès,
cet appareil doit être relié à la terre.
DANGER
Pour éviter tout risque d’électrocution, voire de décès,
ne pas modifier la fiche.
Cet appareil DOIT être relié à la terre. En cas de court-
circuit, la mise à la terre réduit les risques d’électrocution
en permettant au courant électrique de passer par un fil.
Ce four est muni d’un cordon équipé d’un fil de mise à la
terre avec une fiche de mise à la terre. La fiche doit être
branchée dans une prise correctement installée et mise
à la terre.
Consulter un électricien ou un prestataire de service
qualifié si les instructions de mise à la terre ne sont pas
bien comprises ou si un doute subsiste quant à la mise à
la terre correcte de l’équipement.
Ne pas utiliser de rallonge. Si le cordon d’alimentation de
l’appareil est trop court, demander à un électricien
d’installer une prise de courant à trois trous. Ce four doit
être branché sur un circuit indépendant de 60 Hz dont la
puissance nominale est indiquée sur l’illustration
correspondante. Lorsqu’un four à micro-ondes est
branché sur un circuit avec d’autres appareils, les temps
de cuisson pourront être prolongés et des fusibles
pourraient sauter.
Modéle NEMA Réception and
Fiche
RCS10
RCS10MP
RCS10MPS
NEMA
5-15R/5-20P
120V-15AMP
RFS10S
RFS12S
RF12MPS
NEMA
5-20R/5-20P
120V-20AMP