5
A/C OUTLET
INPUTS
The A/C convenience outlet is fitted so
that other components can be powered
when the AC line cord of your amplifier is
plugged into mains outlet.
You must fit an Standard 3 pin plug,
available from most specialist dealers.
All audio Inputs and tape outputs are via
gold plated RCA type phono connectors.
All the phono sockets on your AMC
amplifier are marked "L" for left and "R"
for right channels, with the left channels
nearer the top of the cabinet. Your
connection leads will have a white or
black plug for left, and a red plug for right.
Note: The A/C outlet is UNSWITCHED by
the power switch on your amplifier.
The maxinum output current rating
of A/C outlet is 1A.
UNDER NO CIRCUMSTANCES SHOULD
THE CASE OF THE AMPLIFIER BE
OPENED BY ANYONE OTHER THAN A
QUALIFIED ENGINEER, AS DANGEROUS
VOLTAGES ARE PRESENT INSIDE. ANY
UNAUTHORIZED REPAIR MAY INVALIDATE
YOUR WARRANTY.
USB CONNECTOR (XIA50 only)
PHONO INPUT (OPTION COAXIAL IN)
Note:
CD INPUT
TUNER INPUT
AUXILIARY INPUT
TAPE INPUT
The USB connector is for connecting to
computer, other equipments with USB,
LAN and so the Internet.
The analog output of the USB connector
is in parallel with auxiliary input.
This input is suitable for both moving
magnet and moving coil cartridges. For
either type of cartridge the plugs on your
turntable lead should be connected to the
phono input sockets on the rear panel of
your amplifier.
A switch adjacent to the disc input
sockets allows the selection of either MM
or MC input. Facing the back of the
amplifier, move the switch to the right for
use with MM or high output MC cartridges
and to the left for use with normal(low
output) MC cartridges.
Never operate the MM/MC selector
switch with the volume control turned up
as the resultant electrical surge may
damage your loudspeakers.
To minimize hum the turntable lead
should be kept away from the mains
wiring, and any separate turntable ground
lead should be attached firmly to the
earth terminal on the rear of the amplifier.
The PHONO can be replaced with AMC
proprietary designed DAC to convert the
PHONO INPUT into a COAXIAL INPUT.
The CD input is suitable for use with any
CD player. Connect your CD player to the
amplifier using the phono sockets marked
"CD".
The Tuner input is suitable for use with
most AM/FM tuners. Connect your tuner
to the amplifier using the phono sockets
marked "Tuner".
The Auxiliary input is suitable for use with
any extra source processing a line level
output, perhaps a second tuner or CD
player, or an additional tape or video
recorder wired for replay only.
The auxiliary input is in parallel with the
analog output of the USB connector.
This input is suitable for use with most
cassette, reel to reel or video recorders.
Connect the "record" leads of your tape
recorder to the phono sockets marked
"Tape out" on the rear of your amplifier
using phono/phono leads.
To Next Page
Loading...
Need help?
General
