Angelo Po 1G0FT1G User Manual

IT
AUS
DE
FR
ES
C139603300_1.fm
- 15 -
REPLACING PARTS 9
RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, ac-
tivate all the safety devices provided and decide
whether staff at work and those in the vicinity
should be informed. In particular, turn off the gas
supply tap and prevent access to all devices which
might cause unexpected health and safety hazards
if turned on.
If work parts have to be replaced, use original spare
parts only.
The manufacturer declines all responsibly for injury
or damage to components due to the use of non
original parts, or extraordinary work on the appli-
ance which may modify the safety requirements
without the manufacturer's authorisation.
When ordering components, follow the instructions
provided in the parts catalogue.
REPLACEMENT OF THE BURNER NOZZLE
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off the knob (A).
3 - Undo the screws (B) and
remove the control panel
(C).
4 - Unscrew the nozzle (D)
and replace it with the one
suitable for the type of gas
in use (see table at back
of manual).
5 -Replace the control panel (C) and the knobs (A).
REPLACING THE BURNER AIR BUSHING
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off the knobs (A).
3 - Undo the screws (B) and
remove the control panel
(C).
4 - Slacken the screw (D).
5 - Extract the bushing (E)
and replace it with the
one suitable for the type
of gas in use (see table at back of manual).
6 -Replace the control panel (C) and the knobs (A).
E
D
C
B
IDM-39603309800.tif
B
A
C
B
IDM-39603309700
A
D
11
E

Angelo Po 1G0FT1G Specifications

General

Brand	Angelo Po
Model	1G0FT1G
Category	Commercial Food Equipment
Language	English