AOC CU34G2XP/BK User Manual

10
Wall Mounting
Preparing to Install An Optional Wall Mounting Arm.
This monitor can be attached to a wall mounting arm you purchase separately. Disconnect power before this
procedure. Follow these steps:
1. Remove the base.
2. Follow the manufacturer’s instructions to assemble the wall mounting arm.
3. Place the wall mounting arm onto the back of the monitor. Line up the holes of the arm with the holes in
the back of the monitor.
4. Insert the 4 screws into the holes and tighten.
5. Reconnect the cables. Refer to the user’s manual that came with the optional wall mounting arm for
instructions on attaching it to the wall.
M4
100mm
100mm
Specication of wall hanger screws
：
M4*(10+X)mm, ( X=Thickness of Wall mount bracket )
M=4.0Max
Dk=8.0±0.2
H=2.0±0.1
L=10+X
D3.86-3.96
M4-P0.7
NOTE:VESA mounting screw holes are not available for all models, please check with the dealer or
ofcial department of AOC. Always contact manufacturer for wall-mount installation.
-5°
0° 90°
* Display design may differ from those illustrated.
WARNING:
1. To avoid potential screen damage, such as panel peeling, ensure that the monitor does not tilt downward
by more than -5 degrees.
2. Do not press the screen while adjusting the angle of the monitor. Grasp only the bezel.

AOC CU34G2XP/BK Specifications

General

Brand	AOC
Model	CU34G2XP/BK
Category	Monitor
Language	English