8 9
SET TIME AND DAY
2. Press
or to adjust the hour.
3. Press
, the minutes flash. Press or
to adjust the minutes.
4. Press
, the day flashes. Press or
to adjust day.
5. Press
to end. “DONE” will display.
The thermostat will return to normal mode if no key is
pressed within 3 seconds.
OPERATION & PROGRAMMING
1. Press to enter time setting mode. Hour and
AM/PM are flashing.
UNDERSTANDING PROGRAM SCHEDULES
The daily schedule is split into four sections:
WAKE: 6am-8am – Temperature you would prefer to
wake up to, until you leave for the day.
LEAVE: 8am-5pm – Temperature when you are away
from the house during the day.
RETURN: 5pm-10pm – Temperature you would prefer to
return to, until bedtime.
SLEEP: 10pm-6am – Temperature you would prefer
during the night.
The times shown are the defaults. The start time and
temperature of each section can be changed to fit your
schedule (see page 10).
Event Event designator Start time
Set temps
Heat Cool
1 WAKE 6:00AM 70°F (21°C) 78°F (26°C)
2 LEAVE 8:00AM 62°F (17°C) 85°F (29°C)
3 RETURN 5:00PM 70°F (21°C) 78°F (26°C)
4 SLEEP 10:00PM 62°F (17°C) 82°F (28°C)
OPERATION & PROGRAMMING
UNDERSTANDING PROGRAM SCHEDULES (CONTINUED)
PROGRESSIVE RECOVERY
The Progressive Recovery feature allows the thermostat
to activate the heating and cooling equipment prior to
an event in order to reach the desired temperature at
the start of the next scheduled event.
Example:
Set the Wake time to 6 am, and the temperature to 70°.
The heat will come on before 6 am, so the temperature
is 70° by the time you wake at 6.
To Next Page
Loading...
Need help?
General
