Argo S Series User Manual

Engine System Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH. (519)- 662-2840 FAX (519)- 662-2421
EN-14
29. Gradually and gently begin to raise the power pack assembly out of the engine ac-
cess opening. Photo EN-21 You may have to pry the transmission from the driver’s
compartment to free it from the lower main frame.
EN-20 EN-21
30. Set the power pack on a clean work bench and remove the 4 bolts that secure the
engine to the frame. These bolts are threaded into the engine block from below.
Photo EN-22
31. Using the overhead hoist, remove the engine from the power pack frame.
Photo EN-23
EN-22
EN-23
If the engine is being replaced, you will need to remove all Argo components that are not
available with the new engine. These will need to be reassembled to the new engine.
Components include, throttle cable, choke cable, exhaust manifold, driver clutch, etc.
Assembling the Engine to the Power Pack Frame (Kawasaki)
1. Position the engine on to the power pack frame and align the holes in the block with
the holes of the frame. Photo EN-24

Argo S Series Specifications

General

Brand	Argo
Model	S Series
Category	Offroad Vehicle
Language	English