EN
12
any responsibility over damages caused by the use of such products. Should you need to decalcify your appli
-
ance, please follow the instructions which come with the decalcifying product.
TROUBLESHOOTING
PROBLEMS CAUSE SOLUTIONS
The coffee maker does not
supply boiling water for
tisanes
Air has probably entered the
circuit and deactivated the
pump.
Make sure the tank is properly inserted and
that the water is not below the minimum level.
Repeat the operations described in the
“Preliminaryphasesforuse”paragraph.
The coffee maker does not
supply steam.
There is little water and the
pump does not suck it up.
The steam exit hole on the
dispenser wand is clogged.
Use a pin to unclog the wand.
Make sure the water level in the tank is
normal.
Coffee overowing from
the edges of the lter ring
Probably an excess amount
of ground coffee has been
placedinthelterring
preventingthelterringfrom
being correctly tightened into
its housing.
Theoutletholeofthelter
containing the grounds is
obstructed.
Repeat the operation placing the correct
quantityofcoffeeinthelter.
Residues of coffee grounds have remained
on the seal.
Clean the seal with a toothpick or a sponge.
CleanthelterholderbyusingAriete’s
COFFEE CLEAN pads. If the problem persists
after carrying out the above operations, go to
an Authorized Assistance Center.
Cleantheobstructedholeofthelterwitha
pin.
The coffee is not supplied
or ows too slowly.
It is possible that the scarce
outowofcoffeealsodepends
ontheinsufcientemission
of water from the perforated
showerhead type disc in the
lterringhousing.Infactit
is possible that after a few
months of use, fat or lime
residues can obstruct the disc.
The tanks is not inserted
well. Fit the tank securely by
pushing it as far as it will go.
There is little water and the
pump does not suck it up. Fill
the tank.
The coffee blend is ground too
ne,orexcessivelytampered.
Checktheltercontainingtheground
coffee. If the holes are blocked they should
be cleaned using a small brush or using a
suitable tool. Let boiling water run through
thelterholdertodissolveorremoveany
possible residue of coffee or impurity. For
best results, use COFFEE CLEAN pads
following the instructions given inside the
package.
Operatethemachinewithoutthelterring,
allowingthewatertoow.
Ifwaterisstillnotowinguniformlythrough
each hole, please contact your nearest
Authorised Service Centre to have your
appliance cleaned.
Try using coarser coffee blends. Tamper
coffeeinsidethelterusinglesspressure.
The coffee is too watery
and cold.
The blend has been ground
too coarsely.
Amorenelygroundblendmustbeusedto
obtain a more concentrated and hotter coffee.
Anyhow, this problem is easily solved thanks
to the Thermocream® system, which always
guarantees hot coffee accompanied by a
reach cream, even with coarsely ground
beans.