4-22 Chapter 4: BIOS setup
4.4.2 LAN Cable Status
This menu displays the status of the Local Area Network (LAN) cable connected to
the LAN (RJ-45) port.
POST Check LAN Cable [Disabled]
Allows you to enable or disable LAN cable check during POST. When enabled, the
menu reports the cable faults or shorts, and displays the point (length) where the
fault or short is detected. Conguration options: [Disabled] [Enabled]
POST Check LAN Cable [Disabled]
LAN Cable Status
Pair Status Length
1-2 Normal N/A
3-6 Normal N/A
4-5 Normal N/A
7-8 Normal N/A
1-2 Open 0.0M
3-6 Open 0.0M
4-5 Open 0.0M
7-8 Open 0.0M
Check PCI Marvell
LAN cable during
POST.
Target Frequency [Overclock 3%]
Allows you to set the maximum overclock percentage for the selected NOS Mode.
Conguration options: [Overclock 3%] [Overclock 5%] [Overclock 7%] [Overclock
10%] [Overclock 15%] [Overclock 20%] [Overclock 30%]
Selecting a very high frequency may cause the system to become unstable. If
this happens, revert to the default setting.
To Next Page
Loading...
Need help?
General
