Recovering the partition
This procedure allows you to delete the Intel
®
Rapid Start Technology from your system, and
recover the partition you made for the Intel Rapid
®
Start Technology installation.
Run the Command Prompt tool.
Type diskpart and press Enter.
At the diskpart prompt, type
list disk after DISKPART,
and press Enter.
Select the disk (SSD) where the
Intel
®
Rapid Start Technology
is installed for volume recovery,
type select disk x
(x = number), and press Enter.
1.
2.
3.
4.
The value “x” refers to a disk number where you want to delete the store partition.
Tick On in the Status eld to enable the function, and click Save.
2.
Click to enable or
disable battery
saving mode. This
function only applies
to notebooks.
Select and click to enable
or disable the function
Click to enable or disable the timer. When enabled, move
the scroll bar to the desired time. When the system is
idle for more than the time period you set, the system
automatically goes into the Intel
®
Rapid Start mode.
Default time is 10 minutes.
Click to save the
settings made.
Click to cancel the
settings made.
To Next Page
Need help?
General
Weight and Dimensions
