1. Stop the machine and wait until the working
tool has cooled down.
2. Fit or remove the working tool.
3. Close the tool retainer by using your foot.
WARNING Vibration hazard
Using inserted tools that do not fulfil the criteria
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
►
Make sure that the inserted tool is well-
maintained, not worn out and of the proper size.
►
Always use a sharp tool in order to work
efficiently.
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
►
Keep your hands away from the start and stop
device until you are ready to start the machine.
►
Learn how the machine is switched off in the
event of an emergency.
WARNING Obstructed air intake
Ensure that the air intake is not obstructed. An
obstructed air intake can lead to an overheated
machine.
Start and stop
Cold start
1. Remove the fuel cap and check the fuel level.
Secure the cap before start.
2. Slide the start button towards the fuel tank.
3. Pump at least 5-10 times on the primer pump.
4. Close the choke by turning the choke control
anticlockwise to position (START).
5. Push the throttle lever down and pull the starter
handle.
6. When the machine ignites, open the choke one
step clockwise towards position (WORK). Let
the machine run for a 30-60 seconds warm up
period then open the choke fully clockwise
towards position (WORK). The machine will
achieve full performance after approximately 5
minutes.
Safety and operating instructions COBRA COMBI
14 © Atlas Copco Airpower | 9800 0955 01 | 2018-01-01
Original instructions
To Next Page
Loading...
Need help?
General
