3. Remove the old starter cord.
Fitting a new starter cord
4. Oil the needle bearing in the starter pulley.
5. Fit the starter pulley and protective cover
together, so that the starting spring locates in
the starter pulley.
6. Wind the full length of the cord onto the pulley.
7. Pre-tension the starting spring by two thirds of
a turn (clockwise) before fitting the assembly
into place.
8. Pull the starting handle carefully, in order to
locate the cover correctly.
9. Fit and tighten the hexagonal bolts and the
PTO screw-cap.
Troubleshooting
If the engine does not start, is difficult to start, runs
unevenly or has poor output, check the points
mentioned below.
◆
Check that the Stop button is in the ON
position.
◆
Check the fuel level.
◆
Check the spark plug’s electrode distance.
◆
Check that the air filter is not blocked.
◆
Check that the fuel filter is not blocked.
◆
When drilling, check that the flushing hole in the
drill steel is not blocked.
◆
If the machine still does not work satisfactorily
following this procedure, please contact your
nearest authorised Atlas Copco workshop.
Storage
◆
Empty the tank before storing the machine.
◆
Check that the machine is properly cleaned
before putting it away for storage.
◆
Store the machine in a dry place.
◆
We recommend to store the machine in a
standing position. If stored in a lying position,
the machine must be placed on the back cover.
◆
Keep the machine and tools in a safe place, out
of the reach of children and locked up.
Disposal
A used machine must be treated and disposed of
in such a way that the greatest possible portion of
the material can be recycled and any negative
influence on the environment is kept as low as
possible, and in accordance with local restrictions.
Before a fuel driven machine is deposited it must
be emptied and cleaned of all oil and fuel.
Remaining oil and fuel must be dealt with in a way
that does not adversely affect the environment.
Always send used filters, drained oil and fuel
remnants to environmentally correct disposal.
Safety and operating instructions COBRA COMBI
18 © Atlas Copco Airpower | 9800 0955 01 | 2018-01-01
Original instructions
To Next Page
Loading...
Need help?
General
