6996 0223 70 31
Ensure that the eyebolt is fully wound in to the lifting boss. Ensure eye bolt is in serviceable condition and rated
according to the load.
The motor is also equipped with an eyebolt but is only designed for the motor itself.
Use an eye bolt provided at the pump for lifting the pump assembly. Do not use an eyebolt
at the motor.
Always check the center of gravity while lifting the pump. Note that on some pressure pumps, the weight of the motor
is significant and may cause the pump to lift at an angle.
It is not allowed to lift the pump if the canopy parts or lifting supports are not completely
installed.
When the pump is being lifted, it is also forbidden to come under the load or to perform
maintenance activities to it.
Acclimatization
When moving the pump into an installation room, forming of condense can occur on some
components.
To avoid dew harming of electrical components, ensure at least 2 hours of acclimatization
before switch on the pump.
3.3 Electrical connections
Always use a protection system, including an overcurrent protection and an electrical disconnecting device between
the pump and the electrical power supply. Refer the chapter “Motor data” in this book and motor data plate for motor
current details. The pump is delivered without electrical cable and switch. For the electrical connection, check the
diagram inside the terminal box or on the motor data plate.
Before starting up the machine, check the rotation direction of the motor to prevent pump
failure. Motor rotation direction must be counter clockwise (when viewed from Non-drive
side to drive side) for all motor.
If this is incorrect, switch off the voltage and reverse two incoming electric lines.
For the selection of the correct cables and fuses, refer to section “Electric cable size and
fuses” in this manual.
To Next Page
Loading...
Need help?
General
