Filling procedure
1. Stop the engine and let it cool down before filling
the tank.
2. Release the filler cap slowly to let any pressure
escape.
3. Fill the fuel tank to the lower edge of the filler
pipe.
4. Never overfill the tank. Due to the movement of
the fuel within the tank, it is possible to have fuel
at a higher level than the tank cap, which can
lead to a spillage of fuel if the tank cap is opened.
This can be avoided by only opening the tank
cap, when the machine is tilted and the tank cap
is at the fuel tank's highest point.
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
► Keep your hands away from the start and stop
device until you are ready to start the machine.
► Learn how the machine is switched off in the event
of an emergency.
Start and stop
Before starting
Follow the general safety precautions supplied with
the machine at delivery. We recommend that you
study the engine manual supplied with the machine.
Check that the maintenance routines have been
carried out.
♦
Check the engine oil level on the dipstick. The
rammer must be standing straight up when the oil
level is checked.
♦
Fill the fuel tank with fuel.
♦
Check that all the controls are working.
♦
Make sure that there is no oil leakage, and that
all bolted joints are tightened.
© 2011 Atlas Copco Construction Tools AB | No. 9800 1139 01 | 2011-04-01
Original instructions
14
LT 800Safety and operating instructions
To Next Page
Loading...
Need help?
General
