Atlas Copco ZR Series User Manual

Instruction book
2920 1472 03 21
1.9.2 Display
The following is a typical example of the main screen, showing in short the status of the compressor:
Compressor Outlet 7.0 bar
Automatically Loaded
↓
Menu Unload
F1 F2 F3
Fig. 1.11 Example of the main screen
1.9.3 Function keys (5-Fig. 1.10)
The keys are used:
- to call up or program settings
- to reset an active motor overload, shut-down or service message, or an emergency stop
- to have access to all data collected by the regulator
The functions of the keys vary, depending on the displayed menu. The actual function is indicated on
the bottom line of the display just above the relevant key.
The most common functions are listed below:
Designation Function
Add To add compressor start/stop commands (day/hour)
Back To return to a previously shown option or menu
Cancel To cancel a programmed setting when programming parameters
Delete To delete compressor start/stop commands
Help To find the Atlas Copco internet address
Limits To show limits for a programmable setting
Load To load the compressor manually
Mainscreen To return from a menu to the main screen (Fig. 1.11)
Menu Starting from the main screen (Fig. 1.11), to have access to submenus
Menu Starting from a submenu, to return to a previous menu
Modify To modify programmable settings
Program To program modified settings
Reset To reset a timer or message
Return To return to a previously shown option or menu
Unload To unload the compressor manually
Extra To find information regarding the installed modules

Atlas Copco ZR Series Specifications

General

Brand	Atlas Copco
Model	ZR Series
Category	Air Compressor
Language	English