Configuration Note 2. Restoring Defaults using CLI
Version 6.4 9 May 2012
2 Restoring Defaults using CLI
The device can be restored to factory defaults using the CLI, as described in the procedure
below.
2.1 Establishing CLI Communication
Before you can restore defaults, you need to establish CLI communication with the device.
To restore factory defaults using CLI:
1. Cable the device's RS-232 serial port to the COM1 or COM2 communication port on
your PC. For a detailed description on serial cabling, refer to the device's Installation
Manual.
2. Establish a serial communication with the device, using a serial communication
program such as HyperTerminal. The table below lists the COM port settings.
Table 2-1: COM Port Settings
Parameter Devices Value
Baud Rate
• Mediant 600
• Mediant 800 MSBG
• Mediant 800 Gateway & E-SBC
• Mediant 1000 MSBG
• Mediant 1000
• Mediant 1000B Gateway & E-SBC
• Mediant 2000
• Mediant 3000
• Mediant 4000 E-SBC
115,200 bps
MP-11x 9,600 bps
MP-124 115,200 bps
Data bits
All 8
Parity
All None
Stop bits
All 1
Flow control
All None
To Next Page
Loading...
Need help?
General
